网站首頁   GB 中國國家標準檢索   GB標準關鍵詞 特價英文版GB標準   GB標準檢測及合規性分析 價格和支付方式 聯系我們
 

“Testing method of co ” 中國GB標準檢索結果

1. 已翻譯的GB標準英文版(有 SALE 標誌的),以及GB標準中文版,可以直接在網站上購買,在收到您付款後,會在1~3天內發您郵箱。
2. 其他未翻譯的GB標準英文版,在接到您翻譯訂單後,才進行翻譯,時間一般需要多3~5天。
       
GB/T 33877-2017
無損檢測 螢光滲透劑亮度測定方法(中英文版)
Non-destructive testing—Test method for comparing the brightness of fluorescent penetrants
SY/T 6898-2012
火燒油層基礎參數測定方法(中英文版)
Experimental testing method of in-situ combustion parameters
SY/T 6824-2011
油氣井用複合射孔器通用技術條件及檢測方法(中英文版)
General requirements and testing method of combined perforator for oil and gas well
SY/T 6540-2002
鑽井液完井液損害油層室內評價方法(中英文版)
Lab testing method of drilling and completion fluids damaging oil formation
SY/T 6411.2-2008
油氣井用導爆索通用技術條件及檢測方法 第2部分: 檢測方法(中英文版)
General requirements and testing method of detonating cord for oil and gas well. Part 1: Testing method
SY/T 6411.1-2008
油氣井用導爆索通用技術條件及檢測方法 第1部分:通用技術條件(中英文版)
General requirements and testing method of detonating cord for oil and gas well. Part 1: General requirements
SY/T 6275-1997
石油企業節能監測綜合評價方法(中英文版)
Comprehensive evaluation method for monitering and testing of energy conservation in petroleum enterprise
SY/T 6274-1997
油氣井用導爆索檢測方法(中英文版)
Testing method of detonating cord for oil and gas well
SY/T 5343-2013
濾液侵入岩心量的測定方法(中英文版)
Determination method for testing the amount of filtrate invading core
SY/T 5265-1996
油田注水地面系統效率測試和單耗計算方法(中英文版)
Method for efficiency testing and unit energy consumption calculation of oilfield water-injection surface system
QC/T 817-2009
摩托車和輕便摩托車簧片閥式二次空氣補給機構耐久性要求與試驗方法(中英文版)
Durability requirements and testing methods of reed valve type second air injectors for motorcycles and mopeds
QC/T 801-2008
摩托車和輕便摩托車簧片閥式二次空氣補給機構技術要求和試驗方法(中英文版)
Technical requirements and testing methods of reed valve type second air injectors for motorcycles and mopeds
QC/T 29105.3-2013
專用汽車液壓系統液壓油固體顆粒污染度測試方法 取樣(中英文版)
Sampling methods of testing particulate contamination of hydraulic oil of special purpose vehicle hydraulic system
FZ/T 93086.2-2012
集聚紡紗用網格圈試驗方法 第2部分:空隙率(中英文版)
Testing method of lattice apron for compact spinning process. Part 2: Interstice rate
FZ/T 93086.1-2012
集聚紡紗用網格圈試驗方法 第1部分:內周長(中英文版)
Testing method of lattice apron for compact spinning process. Part 1: Inner perimeter
FZ/T 50030-2015
化學纖維 膨體長絲(bcf)熱捲曲伸長率試驗方法(中英文版)
Testing method for crimp elongation after heating of man-made bulked continuous filament(BCF)yarns
FZ/T 50016-2011
粘膠短纖維阻燃性能試驗方法 氧指數法(中英文版)
Testing method for flame retardant property of viscose staple fibers. Oxygen index
FZ/T 50009.4-1998
三維捲曲滌綸短纖維膨松性、壓縮彈性試驗方法(中英文版)
Testing method for bulkiness property and compressive elasticity of three-dimensional crimp polyester staple fibres
FZ/T 40006-2011
桑蠶撚線絲含油率試驗方法(中英文版)
Testing method for oil content of mulberry thown silk
FZ/T 40005-2009
桑/柞產品中桑蠶絲含量的測定 化學法(中英文版)
Testing method of mulberry silk content in mulberry silkworm/tussah products. Chemical method
FZ/T 10020-2011
紡織上漿用聚丙烯酸類漿料試驗方法 粘度測定(中英文版)
Testing method for polyacrylic sizes used in textile warp sizing. Determination of viscosity
FZ/T 10017-2011
紡織上漿用聚丙烯酸類漿料試驗方法 殘留單體含量測定(中英文版)
Testing method for polyacrylic sizes used in textile warp sizing. Determination of residual monomer content
FZ/T 10016-2011
紡織上漿用聚丙烯酸類漿料試驗方法 不揮發物含量測定(中英文版)
Testing method for polyacrylic sizes used in textile warp sizing. Determination of involatile substance content
FZ/T 01079-2000
織物燙焦試驗方法(中英文版)
Testing method of scorch for textile fabrics
NB/T 51019-2014
固體充填材料壓實特性測試方法(中英文版)
Method of compaction testing of solid backfilling materials
NB/T 42080-2016
全釩液流電池用離子傳導膜 測試方法(中英文版)
(Testing method of ion conducting membrane for vanadium redox flow battery)
NB/T 42005-2013
高壓交流電機定子線圈對地絕緣電熱老化試驗方法(中英文版)
Test method for thermal voltage-endurance testing on groundwall insulation of stator coil of high voltage AC machines
NB/SH/T 0920-2016
高赫茲接觸壓力下潤滑脂抗微動磨損能力的測定 高頻線性振動試驗機法(中英文版)
(Determination of anti-fretting wear capacity of grease under high Hertz contact pressure - High frequency linear vibration testing method)
HG/T 3660-1999
熱熔膠粘劑的熔融粘度的測定(中英文版)
Testing methods for melt viscosity of hot-melt adhesives
AQ/T 1084-2011
煤礦災變環境混合氣體測試方法與爆炸危險性判定規則(中英文版)
Testing method and judgment standard of explosion hazard for mixed gases in coal mine disaster circumstance

找到:273條目   |  [首頁]-[上一頁]-[下一頁]-[尾頁]  | 去到: 1 2 3 4 5 6 7 8 9 10

 

1F Zhongmao Building, No.1 Beizhan Road, Luohu District, Shenzhen City, China
+86-755-2583-1330        info@transcustoms.com 
©  Copyright 2001-2025  RJS MedTech Inc. All Rights Reserved